Applies to: AC10 v1.0 and the interface documented in Tenda’s Wireless Repeating guide. Other revisions may differ.
The key distinction is who assigns addresses to connected devices. In Tenda’s AC10 v1.0 repeating guide, WISP clients receive addresses from the AC10. In Client+AP mode, the upstream router assigns those addresses. Choose the network arrangement you need before entering the upstream Wi-Fi password.
Sketch the connection first
Write down the upstream router, the AC10 and one device you will use to test. Note which network currently contains a printer or another device you need to reach. This small diagram gives you a reason for the mode choice and something to compare after the change.
| Question | What it tells you |
|---|---|
| Should the upstream router assign the client addresses? | Client+AP matches that address-assignment requirement in the documented interface. |
| Should the AC10 assign addresses to its own clients? | WISP matches that requirement. |
| Do you need the Tenda app to manage the AC10? | Tenda says AC10 app management is available in routing mode, not AP or wireless repeating mode. |
Apply the model-specific setup
For the documented AC10 interface, log in locally and open Wireless Settings > Wireless Repeating. Choose the intended mode, scan for the upstream network, and supply its matching Wi-Fi credentials. For a hidden network, the official guide explains the manual network-name, band and security fields. Save and allow the device to restart.
Check the result before moving the router
Use Internet Status to check the repeating connection. Then test an ordinary website and any local device that matters to you. Record the test client’s address and gateway before and after the change. An unexpected result is a reason to review the chosen arrangement, not to start changing unrelated DNS or firewall settings.
Keep a note of the earlier mode and configuration so you can return to a known setup. This comparison covers wireless repeating; it does not substitute for the wiring instructions for a separate Ethernet-connected access point.
Sources and review notes
Documentation checked 7 October 2026. This independently written guide combines cited documentation with practical diagnostic checklists. It is not a report of hands-on product testing. Model, firmware and app interfaces can change.